Four (4) 4.25" x 4.25" Sublimation Ceramic Tiles, Glossy White

Description

Buy two (2) sets or more: 20% discount
Ceramic Sublimation Tiles
White Glossy
4.25" x 4.25"
Lot of four (4)
Classic choice for custom photo prints,
personalization, gift giving, or colorful murals
Supplies Needed:
- Sublimatable substrate (tile)
- Nomex pad
- Sublimation transfer paper
- Teflon or scratch paper
- Heat tape
- Heat resistance gloves
Heat press settings:
- temp: 400 degrees F
- dwell time: varies depending on tile size
- pressure: light
Dwell time:
- 4.25" x4.25": 4:00 minutes
- 6" x 6": 4:30 minutes
- 6" x 8": 5:00 minutes
- 8" x 8": 5:30 minutes
- 8" x 10": 6:00 minutes
- 12" x 12": 6:30 minutes
Notes:
1. The recommended setting above for sublimation may need
adjustments for best results. Sublimation setting will vary
depending on the heat press brand and model, ink and paper
and atmospheric conditions.
2. The use of Nomex pad or felt pad and the specific layering
of the tile
and transfer allow the tile to press into the pad
which
help wrap the transfer around
the tapered edge of the
tile to
produce a continuous distribution of ink
to the entire
tile
and its
tapered edges.
3. To avoid ink blow-back place a sheet of scratch paper on
top
of the Nomax pad/felt pad. This will extend the life of the
Nomax pad and prevent discoloration
and contamination
from
the ink to the pad.
Sublimation Instructions:
Layer the press from the bottom pad to the top heat platen as follows:
1. teflon sheet or scratched paper
2. Nomex pad
3. Scratch paper (optional but recommended)
4. transfer paper (face up)
5. substrate (tile - face down)
5. teflon sheet or scratch paper
Steps:
1. Wipe the substrate with lind-free cloth to remove any debris
if necessary
2. Position the substrate face down onto the transfer paper
3. tape 2 ends of the substrate to the trans
fer
paper using heat
tape
4. Place thin piece of scratch paper/butcher paper onto Nomex
pad to protect pad from blow-back ink
5. Place transfer paper and substrate in the the press onto the
Nomex pad (transfer p
aper is under the tile face up; tile is on
top
face down)
6. Place teflon sheet or scratch paper over the transfer paper
and
substrate
7. Press items using the sublimation settings above - See
above
for dwell time for various sizes
8. Remove items from the press immediately. Use heat
resistance
gloves - the items will be very hot
9. Tear transfer paper in half opposite of the taped ends and
allow
several minutes to cool
Free US Shipping to Lower 48 States